Volume and fades change the level of a selected audio interval. They can make a clip begin or end more gently, but they do not remove background noise, isolate a voice or repair clipping already present in the source. Use modest changes and judge the rendered output with the sound you need to preserve.
Know what the controls mean
Volume runs from 0% to 200%. At 100%, the gain multiplier is one; 50% halves sample amplitude and 200% doubles it. The percentage is not a perceived-loudness score. Increasing it can push peaks beyond the representable range; the WAV export clamps those peaks and can introduce clipping. A louder result is not automatically a clearer recording.
Fade-in and fade-out are durations in seconds within the kept interval. The current renderer uses linear level ramps. A two-second fade-in starts at the beginning of the output, even if Start is set to a later position in the source. A fade-out ends at the output's end. There are no fade-curve presets or automatic loudness normalization controls.
Apply one change at a time
- Open the Audio Editor and choose a supported 16-bit PCM WAV. Input is limited to 20 MiB, three minutes, one or two channels and a sample rate of 8,000–96,000 Hz.
- Set Start and End to the section you want. Listen to the source around both boundaries. Begin with volume at 100% and fades at zero to establish a reference.
- Enter a short fade-in or fade-out in seconds. Both must be nonnegative, and their sum must not exceed End minus Start. For a ten-second interval, fades of two and three seconds fit; fades of six and five do not.
- Adjust volume only if needed. If increasing it produces rough or distorted peaks, reduce the gain rather than expecting the export to repair them.
- Process with valid editor access. Listen to the result player, especially the first and last words and loud passages, then download the WAV.
Preview the rendered result
The source player lets you hear the original file. It does not continuously apply pending gain and fade values. Process the edit to create the result you can audition. After a settings change, the old output is cleared so that it cannot be mistaken for the new settings.
Listen through headphones or speakers appropriate to the intended use. A long fade may make speech hard to hear even when the controls are valid. If a click remains at a cut, reconsider the boundary and try a short fade; do not keep extending it until wanted sound disappears. For timing rules, see trimming by start and end time.
Recover from rejected settings
Check that all values are finite, Start is at least zero, End is later than Start and no later than the source duration. Volume must remain within 0–200%, and both fade durations must fit together in the selected interval. These conditions apply even when a field individually looks reasonable.
The editor outputs a new PCM WAV, preserving the source's supported sample rate and channel count. It has no direct MP3 export. Save the result before leaving the page; download requires current account access. If you need another delivery format, choose the saved WAV in the converter as a separate step and check its input size. Keep the original so a later edit can start without compounded processing.